The paper published the results of studies on the mechanism of destruction submersible solids separator. It has been established that the cause of failure is the accumulation of solids in the central part of the separator. A new design of the separator, wherein the vertical component of particle velocity prevents their accumulation and the rate of wear sleeve 10 times lower than that of the reference design.
References
1. Devitskiy V.N., Field tests of the equipment in the complicated conditions
(In Russ.), Inzhenernaya praktika, 2011, no. 2, pp. 90–92.
2. Antipina N.A., Kaplan A.L., Peshcherenko S.N., Submersible separators for solids management (In Russ.), Burenie i neft', 2011, no. 12, pp. 40–43.
3. Armentor R.Dzh., Boumen M., Kavatsolli G. et al., Sand recovery control of production wells (In Russ.), Review, Neftegazovoe obozrenie, 2007, pp. 4–17.
4. Soboleva E.V., Analysis of formation and methods of fighting against asphaltene, resin and paraffin deposits in wells during oil production of Upper
Prikam''e fields (In Russ.), Vestnik Permskogo natsional'nogo issledovatel'skogo politekhnicheskogo universiteta. Geologiya. Neftegazovoe i gornoe delo, 2013, no. 8, pp. 71–77.
5. Den'gaev A.V., Verbitskiy V.S., Drozdov A.N. et al., Development of the principles of centrifugal separation of mechanical impurities at the reception ESP (In Russ.), Territoriya Neftegaz, 2007, no. 10, pp. 26–28.
6. Markelov D.V., Tsentrobezhnaya separatsiya gaza i tverdykh chastits v
priemnykh ustroystvakh pogruzhnykh nasosnykh ustanovok dlya dobychi
nefti (Centrifugal separation of gas and solid particles in the receivers of submersible pumping systems for oil extraction): Thesis of candidate of technical science, Moscow, 2007.
7. Bulat A.V., Povyshenie effektivnosti raboty skvazhinnogo nasosnogo oborudovaniya za schet primeneniya separatorov mekhanicheskikh primesey (Improvingn the efficiency of downhole pumping equipment by applying of mechanical impurities separators): Thesis of candidate of technical science,
Moscow, 2013.
8. Den'gaev A.V., Drozdov A.N., Verbitskiy V.S., Exploring the causes of the
"flight" gas separators as a part of the ESP (In Russ.), Territoriya Neftegaz, 2005, no. 11, pp. 50–54.
9. Lambin D.N., Sviderskiy S.V., Comparative tests on durability domestic centrifugal gas separators (In Russ.), Neft', Gaz i Biznes, 2010, no. 4, pp. 78–83.
10. Ostrovskiy V.G., Perel'man M.O., Peshcherenko S.N., The mechanism of
hydroabrasive destruction of submersible gas separators (In Russ.), Neftyanoe
khozyaystvo = Oil Industry, 2013, no. 5, pp. 100–102.
11. Ostrovskiy V.G., Perel'man M.O., Peshcherenko S.N., Mechanism of hydroabrasive wear of oil pumps' stages (In Russ.), Burenie i neft', 2012, no. 10, pp. 36–38.
12. Ostrovskiy V.G., Peshcherenko S.N., Calculations of the rate hydroabrasive wear interstage seal oil pump (In Russ.), Vestnik Permskogo natsional'nogo issledovatel'skogo politekhnicheskogo universiteta. Geologiya. Neftegazovoe i gornoe delo, 2012, no. 5, pp. 70–75.
13. Brusova O.M., The problem of increasing soil pumps lifetime (In Russ.), Vestnik Permskogo natsional'nogo issledovatel'skogo politekhnicheskogo universiteta. Geologiya. Neftegazovoe i gornoe delo, 2014, no. 10, pp. 98–106.
14. Patent no. 2379500 RF, Abrasive-resistant centrifugal gas tank, Inventors:
Peshcherenko S.N., Peshcherenko M.P., Rabinovich A.I., Perel'man M.O.,
Dorogokupets G.L., Ivanov O.E., Kuprin P.B., Mel'nikov M.Yu., Gurkin A.M., Nagiev A.T., Kaplan A.L.
15. Patent no. 2526068 RU, kl. E21B43/38, Downhole separator of mechanical impurities, Inventors: Ostrovskiy V.G., Peshcherenko M.P.,
Peshcherenko S.N. et al.
