Processing and test of turbulent viscosity reducing additive with nanocomponents

UDK: 665.7.035.6
DOI: 10.24887/0028-2448-2017-4-117-120
Key words: oil, flow properties, viscosity reducing, turbulent viscosity reducing additives (or anti-turbulent additives), hydraulic resistance, diesel fuel fraction, Reynolds number
Authors: G.I. Dusmetova, A.V. Sharifullin, E.V. Kharitonov (Kazan National Research Technological University, RF, Kazan) V.N. Sharifullin (Kazan State Power Engineering University, RF, Kazan)

Modern requirements for turbulent viscosity reducing additives involve certain flexibility: a combination of viscous and anti-turbulent properties while maintaining the stability to various types of destruction. Currently in use additives do not fully comply with these requirements.

We developed a composition (additive) consisting of nanoparticles (20-30 nm), low molecular weight polymer and surface-active substance Reapon-4V. The action of adsorption forces of leads to formation of new linear structure of pseudo-polymer with a higher molecular weight than the starting polymer. The higher molecular weight of the polymer is the greater flow resistance decreases. On the other hand the additive having a very high molecular weight is unstable to mechanical degradation. We have developed a composition more resistant to mechanical degradation due to the effect of the periodic destruction and restoration of the structure. Initially, the polymer is adsorbed on the nanoparticle surface, forming a new linear structure of high molecular weight, and thereby a reduction in flow turbulence and as a result, reducing hydrodynamic drag. Passing through the pseudo-polymer pump, breaks down. Then, in a stream of moving fluid again, polymer adsorption occurs again on the surface of nanocomponents and the formation of "macromolecules". The presence of surface-active substance, together with the polymer allows this dispersed system be in the steady aggregation state, without allowing nanocomponents particles to coagulate in the solution. It was established that the synthesized additive with nanocomponents we have, under turbulent flow stream acts as an anti-turbulent and as a viscous. The effect of additives, due to decreased viscosity of the medium, appears greater at temperatures close to 0 C and in small pumping velocities.

Additive comprising of nanocomponents is effective "viscose" properties at low shear rates, thus reducing the energy consumption at the initial stage of movement of oil (in laminar and transitional mode). The action of nanocomponents in reducing viscosity decreases with increasing turbulence flow.

Hydrodynamic efficiency of developed additives with nanocomponents is higher than that of industrial anti-turbulent M-FLOWTREAT additives for a diesel fraction. It can be assumed that on oils (a more viscose medium) this difference will be more


1. Klimko V.I., Obosnovanie ratsionalnogo temperaturnogo rezhima truboprovodnogotransporta vysokovyazkoy i vysokozastyvayushchey nefti (Justificationof a rational temperature mode of high-viscosity and high-solidifyingoil pipeline transport): thesis of candidate of technical science,St. Petersburg, 2014.

2. Sherstnev N.M., Gurvich L.M., Bunina I.G. et al., Primenenie kompozitsiyPAV pri ekspluatatsii skvazhin (The use of surfactant compositions in the welloperation), Moscow: Nedra Publ.,, 1988. 184 s.

3. Terteryan R.A., Depressornye prisadki k neftyam, toplivam i maslam(Depressant additives to crude oil, fuels and oils), Moscow: Khimiya Publ.,1990, 234 p.

4. Fakhrutdinov R.Z., Ganieva T.F., Nizkotemperaturnye kharakteristikineftyanykh topliv i masel. Metody opredeleniya i sposoby ikhuluchsheniya. Depressornye prisadki k toplivam i maslam (Low-temperaturecharacteristics of petroleum fuels and oils. Methods for determiningand ways of their improvement. Depressant additives for fuels and oils),Kazan: Publ. of KSTU, 2012, 83 p.

5. Mjagchenkov V.A., Krupin S.V., Chichkanov S.V., The Influence of natureand concentrations of water-soluble (co)polymers and their mixtures onvalue of Toms phenomenon (In Russ.), Neftyanoe khozyaystvo = Oil Industry,2002, no. 12, pp. 118119.

6. Rukovodstvo po ekspluatatsii programmiruemogo viskozimetra Brukfil-da DV-II+PRO (Operating manual of programmable Brookfield viscometerDV-II + PRO), Moscow, 2011, 89 p.

7. Khusnullina R.R., Kompozitsionnye sostavy dlya snizheniya gidravlicheskogosoprotivleniya v sistemakh truboprovodnogo sbora i transportaproduktsii neftyanykh skvazhin (Blend composition for reduce the hydraulicresistance in the pipeline system of collect and transport the oil wells product):thesis of candidate of technical science, St. Petersburg, 2015.

8. Sharifullin A.V., Baybekova L.R., Sharifullin V.N., Dusmetova G.I., Developmentand testing of heavy oil viscosity reducer (In Russ.), Neftyanaya provintsiya,2015, no. 3, pp. 115126, URL:

To buy the complete text of article (a format - PDF) or to read the material which is in open access only the authorized visitors of the website can. .

Mobile applications

Read our magazine on mobile devices

  Google play

Press Releases